- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Experimental Investigations of Hole - EDM to Optimize ElectrodeWear through Full Factorial of Design of Experiment | ||
| Engineering and Technology Journal | ||
| Article 1, Volume 33, 2A, 2015, Pages 372-379 PDF (174.67 K) | ||
| DOI: 10.30684/etj.33.2A.10 | ||
| Authors | ||
| Shukry H. Aghdeab; Laith A. Mohammed | ||
| Abstract | ||
| Electrical discharge machining (EDM) is a process where the material removal of the workpiece is achieved through high frequency sparks between the tool (electrode) and the workpiece immersed into the dielectric solution. It is commonly used to produce moulds and dies, to drill small, burr free holes and to make prototypes for the aerospace and electronics markets. In this work, micro-holes were fabricated on copper alloys by using EDM. The output responses investigated was electrode wear weight (EWW). Full factorial of Design of Experiment (DOE) module in Minitab was used as a principal methodology to examine the effects of current and machining time over output responses. Experimental results indicate that the EWW was mainly affected by current, and can be reduced by increasing the current parameter. Minimum EWW (0.12gm) obtained at 10A. | ||
| Keywords | ||
| micro; EDM; Design of Experiments; Full Factorial Design | ||
|
Statistics Article View: 485 PDF Download: 258 |
||