- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Manufacturing of Aluminum Foam as a Light Weight Structural Material | ||
| Engineering and Technology Journal | ||
| Article 1, Volume 34, 5B, 2016, Pages 697-702 PDF (748.7 K) | ||
| DOI: 10.30684/etj.34.5B.9 | ||
| Authors | ||
| Safa Hasan Mohammed; Ali A. Aljubouri | ||
| Abstract | ||
| In this study, aluminum foam was fabricated using sintering and dissolution process (SDP). Aluminum powder with a particle size (3.63μm) as a raw material was mixed with NaCl with a particle size between (212-400μm) as a space holderat different ratio (30, 40, 50 ,60, 70 and 80) wt. % and compacted at 200 MPa followed by sintering at 650° C for 2 hrs. The sintered samples were placed into hot water for 10 hrs to dissolve NaCl particles. Uniaxial compression test was carried out to determine the foam structure influence on plastic deformation and damage in the Al foam. The foam porosity increased from 28% to 81% for 30wt. % and 80wt. % of NaCl content respectively. The mechanical properties (compressive strength, yield stress and young’s modulus) decrease with increasing NaCl content. | ||
| Keywords | ||
| Sintering and dissolution process; aluminum foam; NaCl space holder; SDP; metal foam | ||
|
Statistics Article View: 304 PDF Download: 132 |
||