- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Optimization of Surface Roughness for Al-alloy in Electro-chemical Machining (ECM) using Taguchi Method | ||
| Journal of Engineering | ||
| Article 1, Volume 23, Issue 10, 2017, Pages 62-71 | ||
| Authors | ||
| Safaa Kadhim Ghazi; Shukry Hammed Aghdeab; Mostafa Adel Abdullah | ||
| Abstract | ||
| Electro-chemical Machining is significant process to remove metal with using anodic dissolution. Electro-chemical machining use to removed metal workpiece from (7025) aluminum alloy using Potassium chloride (KCl) solution .The tool used was made from copper. In this present the optimize processes input parameter use are (current, gap and electrolyte concentration) and surface roughness (Ra) as output .The experiments on electro-chemical machining with use current (30, 50, 70) A, gap (1.00, 1.25, 1.50) mm and electrolyte concentration (100, 200, 300) (g/L). The method (ANOVA) was used to limit the large influence factors affected on surface roughness and found the current was the large influence factors with (72.17%). The results of the optimization of comparison of experimental and prediction conditions current at level-1(30 A), gap at level-1 (1.00mm) and electrolyte concentration at level-1(100(g/L)) shown the average experiments and prediction surface roughness (1.352) and (1.399) respectively. | ||
| Keywords | ||
| Electro; chemical machining; Surface Roughness; Optimization; Taguchi; ANOVA | ||
|
Statistics Article View: 87 PDF Download: 62 |
||