Dry Sliding Wear Behavior of EN25 Steel Treated by Different Quenching Media

Ali Ahmed, Bassam

	Dry Sliding Wear Behavior of EN25 Steel Treated by Different Quenching Media
Journal of Engineering
Article 1, Volume 23, Issue 10, 2017, Pages 72-84
Author
Bassam Ali Ahmed
Abstract
The present investigation aims to study the effect of heat treatment by quenching in different quenching media (salt water, water and oil) following by tempering on wear resistance of EN25 steel. EN25 steel is an alloy of medium carbon low alloy steel which is used for many applications requiring high tensile strength and wear resistance such as connecting rods, adapters and in power sectors extensively. The specimens are machined to 20 mm in length and 10 mm in diameter. This study is done by two stages: The first stage is done by austenitizing EN25 steel to 850℃ for 1 hr by quenching the specimens in three different quenching media and then tempered at 300℃ in air. While the second stage is performed by wear test. Dry sliding wear test is done by using pin –on-disc technique by varying the loads as 5, 10, 15, 20 and 25 N, also varying the time as 5, 10, 15, 20, 25 and 30 min respectively. The microstructure examination, hardness and followed roughness tests are also done for the specimens before and after wear test. The results of this work showed that an improving in wear resistance and hardness for the specimen quenched by salt water more than for water and oil. At the same time the roughness decreasing for the specimen quenched by salt water more than for water and oil.
Keywords
Steel; quenching heat treatment; Quenching Media; wear

Statistics Article View: 187 PDF Download: 164