- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Optimization of MRR and Surface Roughness for 7024 AL-alloy in EDM Process | ||
| Engineering and Technology Journal | ||
| Article 1, Volume 35, 5A, 2017, Pages 546-553 PDF (988.9 K) | ||
| DOI: 10.30684/etj.35.5A.15 | ||
| Authors | ||
| M.M. Abdulrazaq; S.K. Ghazi | ||
| Abstract | ||
| Electro discharge machining is major non-traditional operations for cutting the materials due to its suitability and benefits. The experimental work of this paper deals with electrico discharge machining (EDM). A system for machining in this process has been developed. Many parameters are studied such as current, time on and time off. Different current rates are used ranging from (30, 36 and 42) Amp, found that low current gives less material removal rates and good surface roughness. The results showing that maximum MRR is achieved (0.525) mm3/min when machining current (42), time on (150), and time off (50) while good surface roughness (2.11 μm) when machining current (30), time on (50), and time off (25).The level of importance of the machining parameters for surface roughness and material removal rate is determined by using Taguchi design experiments and analysis of variance (ANOVA). | ||
| Keywords | ||
| Taguchi method; EDM; Surface Roughness; material removal rate | ||
|
Statistics Article View: 369 PDF Download: 260 |
||