- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Study the Effect of Multilayer Single Point Incremental Forming on Tool Path Mark for AA1050 bottom plates | ||
| Engineering and Technology Journal | ||
| Article 1, Volume 35, 6A, 2017, Pages 648-652 PDF (755.13 K) | ||
| DOI: 10.30684/etj.35.6A.13 | ||
| Authors | ||
| A.H. Abed; A.S. Bedan; M.F. Noori | ||
| Abstract | ||
| Single Point Incremental Sheet Forming (SPIF) is an innovative forming approach for sheet materials. One of the most problems in products produced by incremental sheet metal forming process is the poor textures caused by the tool and tool path marks on the products, due to friction between the tool and blank material. In this study, a new method and procedures were proposed which is called (Multilayer single point incremental forming) to overcome this problem by using an insert blank beside the original one with the same material but change in thickness of top plate at 0.5, 0.7, 0.9 mm and change material or lubrication between two plates such as (polymer, grease, grease with graphite, mos2 (Molybdenum disulfide) and without lubricant). Results revealed improvement in surface quality of bottom plates when using Grease with graphite or polymer gives a better result and reduced tool path marks more than other lubricants or material, which have been used. | ||
| Keywords | ||
| Single Point Incremental Forming; Tool Path Marks; surface quality | ||
|
Statistics Article View: 367 PDF Download: 212 |
||