EXPERIMENTAL AND NUMERICAL STUDY OF  NATURAL CONVECTION BETWEEN TILTED WALLS WITH ATTACHED FINS

Abed Al Abas Siba, Mohamed; Audaa Jehhef, Kadhum

	EXPERIMENTAL AND NUMERICAL STUDY OF NATURAL CONVECTION BETWEEN TILTED WALLS WITH ATTACHED FINS
Iraqi journal of mechanical and material engineering
Article 1, Volume 18, Issue 2, 2018, Pages 253-276
Authors
Mohamed Abed Al Abas Siba; Kadhum Audaa Jehhef
Abstract
The free convection between two tilted adiabatic plates with centered heated horizontal cylinder with attached plate fin was investigated experimentally and numerically. The experimental rig constructed from vertical adiabatic was filled with air plates with aspect ratio of (A= 12) tilted by angles of (15o, 30o, 45o, 60o, 75o, and 90o). A horizontal heated cylinder with diameter of (16 cm) subjected under constant heat flux of (100, 500, 700, and 1000 W/m2), the Rayleigh number ranging from (3.5 ×107 to 4.5 ×109). At the bottom of the rig left an opining with distance of (2, 4, 6, and 8 cm) but the upper left open to the atmosphere. The tested cases was of (without fin, smooth, triangular, square, and semi-circle fin) was attached to the right wall of the cavity. The numerical solution of the case was performed by solving the governing equations by ANSYS-FLUENT 14.0 package that dependent upon the finite volume method. The experimental results show that the Nusselt number increases with increasing Rayleigh number, decreasing the inclination angle, increasing heat flux and with increasing the bottom opining distance. Basically, the results showed that the using fins with any geometry will lead to increase the heat transfer rate. The optimum increasing in the Nusselt number was found by using triangular plat fin. Finally, the experimental data was compared with a numerical calculation and found that there is a good agreement in the same conditions
Keywords
Natural Convection; parallel wall; heated cylinder; attached fins

Statistics Article View: 99 PDF Download: 69