- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Push out bond strength of different obturation systems (An in vitro study) | ||
| Journal of baghdad college of dentistry | ||
| Article 1, Volume 23, Issue 3, 2011, Pages 37-43 | ||
| Authors | ||
| Hussain F. Al-Huwaizi; Yasameen H. Motea Al- Ani | ||
| Abstract | ||
| ABSTARCTBackground: The bond strength of the root canal sealers to dentin seems to be a very important property formaintaining the integrity and the seal of root canal filling. The aim of this study was to evaluate the shear bondstrength of four different obturation systems using push-out test.Materials and methods: Forty straight palatal roots of the maxillary first molars teeth were used in this study, theseroots were instrumented using crown down technique and ProTaper system, instrumentation were done with copiousirrigation of 2.5% sodium hypochlorite and 17% buffered solution of EDTA was used as final irrigant followed by distilledwater, roots were randomly divided into four groups according to the obturation system (ten teeth for each group):Group I: AH26 sealer and lateral condensation technique, Group II: AH26 sealer and single cone obturationtechnique, Group III: AH26 sealer and thermafil obturation technique and Group IV: RealSeal SE sealer and lateralcondensation technique, the roots then stored in moist environment at 37°C for one week The roots wereembedded in clear acrylic resin and each root sectioned into three levels apical, middle and cervical. Themeasurement of each section was taken to prepare the supporting jig for the sections and the punch used in pushouttest, the bond strength was measured using computerized universal testing machine each section fixed in themachine so that the load applied from apical to cervical direction at 0.5mm/min. speed and the computer drewcurve to show the higher bond force before dislodgment of the filling material. These forces were divided by thesurface area to obtain the bond strength in MPa.Results: Statistical analysis was performed and the result showed avery highly significant differences between the fourobturation systems at each level and there were non significant differences between all level apical, middle andcervical within each obturation system except a significant difference found between cervical and apical level insingle cone obturation system.Conclusion: This study showed that the shear bond strength of AH26 sealer was higher than RealSeal SE sealer whenthe same obturation technique was used. The shear bond strength was affected by the obturation technique andlateral condensation technique showed higher bond strength than thermafil and single cone obturation techniquewhen the same type of sealer was used and the bond strength was not or little affected by the tooth level.Key words: bond strength, push-out test, endodontic sealers, obturation systems. (J Bagh Coll Dentistry 2011;23(3): 37-43). | ||
|
Statistics Article View: 29 PDF Download: 20 |
||