- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Effect of the Curing Methods on the Surface Hardness of Different Thickness on Heat–Cured Acrylic Resin. | ||
| Al-Rafidain Dental Journal | ||
| Article 1, Volume 7, Issue 3, 2007, Pages 1-4 PDF (2.39 M) | ||
| Document Type: Research Paper | ||
| DOI: 10.33899/rden.2006.164380 | ||
| Authors | ||
| Luay N Abood; Lamia T Rejab; Ahmad M Ali | ||
| Prosthodontic Department, College of dentistry, Mosul university Prosthodontic Department, College of dentistry, Mosul university | ||
| Abstract | ||
| Aims: To evaluate the surface hardness of the heat–cured acrylic resins with two different thicknesses cured by two curing methods conventional water bath and microwave energy. Materials and Methods: Heat–cured acrylic resin was used in this study. Rectangular specimens were prepared with two different thicknesses (3 and 6mm) and cured by two different curing methods, conventional water bath and microwave energy methods. The specimens were divided into two groups according to the curing method and specimens thickness. Forty specimens were prepared, ten specimens for each group. The surface hardness was evaluated with Rock well hardness tester. Mean values wear compared statistically with one way analysis of variance (ANOVA) followed by Duncan' s multiple range test to determine the significant different among the groups at (p<0.05) level of significance. Results: The results showed that there is a highly significant difference of the means value of the surface hardness among the four tested groups. Specimens cured by conventional water bath with 3mm thickness have the highest value in relation to 6mm thickness of specimens cured by microwave energy. Conclusions: The curing method, and specimens thicknesses have a significant effect on the specimens surface hardness value. The specimens that cured by the conventional water bath method have a higher values than that cured by the microwave energy curing method and the thicker specimens have a lower values than the thinner one in both curing methods. | ||
| Keywords | ||
| Surface Hardness; heat–cured acrylic resin; conventional water bath; Microwave | ||
|
Statistics Article View: 223 PDF Download: 284 |
||