- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Performance Improvement of a Conventional Hydraulic Elevator by Using Electro-Hydraulic Servo Mechanism | ||
| Engineering and Technology Journal | ||
| Article 13, Volume 38, 5A, 2020, Pages 748-760 PDF (780.19 K) | ||
| DOI: 10.30684/etj.v38i5A.367 | ||
| Authors | ||
| Jamal AK. Mohammed; Walaa M. Hashim; Bahaa S. Beram | ||
| Electromechanical Engineering Department, University of Technology-Iraq. | ||
| Abstract | ||
| An electro-hydraulic elevator is a new type of enhanced elevators that are used in low-rise buildings that do not exceed more than three floors. In this paper, an electro-hydraulic servo system for controlling the speed of a hydraulic elevator prototype by using a proportional valve and PID controller was investigated theoretically and experimentally. A three floors elevator prototype model with 76cm height was built including hydraulics components and electrical components. The elevator system is fully automated using the Arduino UNO board based Data Acquisition (DAQ) system. LabVIEW software is used to control the hydraulic elevator system through L298 DC drive via the DAQ board. The best PID gains was obtained experimentally. The elevator system prototype could be emplimented for educational purposes; such as learning the undergraduate students in the Electromechanical Engineering Department in the University of Technology how to structuring the electro-hydraulic elevator as well as the appropriate control strategy. | ||
| Keywords | ||
| Electro-hydraulic; servo mechanism; Elevator; proportional valve; PID controller | ||
| References | ||
|
[1] J. M. Hassan and M. W. Moayed, “The effect of hydraulic accumulator on the performance of hydraulic system,” Journal of Engineering, Vol.20, No.7, pp.174-190, 2014. [2] A. A. M. H. AL-Assady, and M. T. J. AL-Khafaji, “Design and analysis of electro-hydraulic servo system for speed control of hydraulic motor,” Journal of Engineering, Vol.19, No.5, pp.562-573, 2003. [3] Y. Huayong, Y. Jian, and X. Bing, “Computational simulation and experimental research on speed control of VVVF hydraulic elevator,” Control Engineering Practice, Vol.12, No.5, pp.563-568, 2004. [4] V. I. Forental, M. V. Forental, and F. M. Nazarov, “Investigation of dynamic characteristics of the hydraulic drive with proportional control,” Procedia Engineering, Vol.129, pp. 695-701, 2015. [5] Z. Liu, Z. Gao, N. Yang, Y. Huo, and J. Liu, “Research of hydraulic drive control system in hydraulic elevator based on P-Q valve,” Int. Conf. on Mech. Science and Engineering, 2015. [6] H. Yang, W. Sun, and B. Xu, “New investigation in energy regeneration of hydraulic elevators,” IEEE/ASME Transactions on Mechatronics, Vol.12, No.5, pp, 512-526, 2007. [7] X. Xu, and Q. Wang, “Speed control of hydraulic elevator by using PID controller and self-tuning fuzzy PID controller,” 32nd Youth Academic Annual Conference of Chinese Association of Automation (YAS) on 19-21, May 2017. [8] S. Wang, B. Zhang, and Q. Zhong, “Study on control performance of pilot high-speed switching valve,” Advances in Mechanical Engineering, Vol. 9, No.7, pp.1-8, 2017. [9] Z. H. Liu, Q. H. Gao, “The position control of the hydraulic cylinder controlled by the high-speed on-off valve,” Sensors and Transducer, Vol.160, No.12, pp.590-601, 2013. [10] H. E. Merritt, “Hydraulic control systems,” 1st Edition, John Wiley and Sons Inc, New York, US 1967. [11] J. Y. Alaydi, “Modeling and simulation of high-performance symmetrical linear actuator,” International Journal of Scientific & Engineering Research, Vol. 3, No. 8, pp.1-11, 2012. | ||
|
Statistics Article View: 457 PDF Download: 373 |
||