Compressive Performance of Corroded Reinforced Concrete Columns

Radhi, Mushtaq; Hassan, Maan S.; Gorgis, Iqbal N.

doi:10.30684/etj.v38i11A.1545

	Compressive Performance of Corroded Reinforced Concrete Columns
Engineering and Technology Journal
Article 5, Volume 38, 11A, 2020, Pages 1618-1628 PDF (1.21 M)
Document Type: Research Paper
DOI: 10.30684/etj.v38i11A.1545
Authors
Mushtaq Radhi^* ¹; maan s. hassan²; Iqbal N. Gorgis³
¹Civil Eng. Dept., University of Kerbala,56001, Karbala, Iraq
²uviversity of technology
³Civil Eng. Dept., Catholic University, Erbil, Iraq
Abstract
Corrosion of reinforcement has been identified as the deterioration mechanism of reinforced concrete structures, which seriously affects the safety and integrity of structures. The corrosion of the embedded reinforcing steel in concrete is a major problem facing civil engineers today, which initiates 80% of the reinforced concrete structures deterioration. This paper reveals the outcomes of an experimental investigation on the mechanical performance (residual strength) of circular steel reinforced columns which have been damaged by corrosion of the steel rebar. Small scale circular reinforced concrete columns with a diameter of 100 mm and 300 mm in height were adopted. Different rates of steel reinforcement mass loss (corrosion damage) ranged between 10%, 20% to 30 % were created in the columns by using a galvanostatic accelerated corrosion method combined with wetting-drying cycles. The uniaxial compression test was implemented for damaged columns up to failure. Based on the experimental outcomes, it was revealed that the corrosion damage had substantially reduced the performance of columns. The decrement of the load capacity of corroded columns ranged between 19% to 40% and for corrosion level ranged from 10% to 30%, respectively. The decrement of the final deformation of corroded columns ranged between 15% to 30% and for corrosion level ranged from 10% to 30%, respectively. Likewise, the failure mode and relationship between the stress and strain for corroded columns had been adversely affected by corrosion.
Keywords
columns; corrosion; mass loss reinforcing steel; ultimate axial strain; ultimate axial strength

References
[1] W. Zhao, Y., & Jin, “Steel Corrosion in Concrete,” Steel Corrosion-Induced Concrete Cracking, p. cp.2 19–29, 2016. [2] M. A. El-Reedy, Steel-Reinforced Concrete Structures: Assessment and Repair of Corrosion, Second Edi. CRC Press, 2018. [3] S. A. Salih, M. S. Hassan, M. F. Al-Rubaie, and A. Yousifany, “Assessment, Protection, and Repairing of Corroded Reinforced Concrete Structure in Iraq,” in The 4th International Scientific Conference of Salahaddin University-Erbil, October 18-20, 2011. [4] M. M. Kashani, D. Ph, J. Maddocks, E. A. Dizaj, and D. Ph, “Residual Capacity of Corroded Reinforced Concrete Bridge Components : State-of-the-Art Review,” vol. 24, no. 7, pp. 1–16, 2019. [5] J. Rodriguez, L. M. Ortega, and J. Casal, “Load Bearing Capacity of Concrete Columns with Corroded Reinforcement,” in Corrosion of Reinforcement in Concrete Construction. Proceedings of Fourth International Symposium, Cambridge, 1-4 July 1996. Special Publication No 183, 1996. [6] J. Revathy, K. Suguna, and P. N. Raghunath, “Effect of Corrosion Damage on the Ductility Performance of Concrete Columns,” American Journal of Engineering and Applied Sciences, vol. 2, no. 2, pp. 324–327, 2009. [7] J. Xia, W.-L. Jin, and L.-Y. Li, “Performance of Corroded Reinforced Concrete Columns Under the Action of Eccentric Loads,” Journal of Materials in Civil Engineering, vol. 28, no. 1, p. 4015087, 2015. [8] S. Altoubat, M. Maalej, and F. U. A. Shaikh, “Laboratory Simulation of Corrosion Damage in Reinforced Concrete,” vol. 10, no. 3, pp. 383–391, 2016. [9] Q. F. Hassan, “Effect of Accelerated Corrosion On Tension Reinforcement On Bending Behavior of Reinforced Concrete Beams,” AL-TAQANI, vol. 26, no. 5, pp. A30–A44, 2013. [10] N. M. Al-Galawi, A. A. H. Al-Tameemi, and S. H. Al-Jarrah, “Effect Of Age And Concrete Cover Thickness On Steel Reinforcement Corrosion At Splash Zone In Reinforced Concrete Hydraulic Structures,” INTERNATIONAL JOURNA L OF SCIENTIFIC & TE CHNOLOGY RESEARCH, vol. 5, no. 9, pp. 129–133, 2016. [11] N. A. Alwash, M. M. Kadhum, and A. M. Mahdi, “External Strengthening of Corrosion-Defected Beam–Column Members Using a CFRP Sheet,” Fibers, vol. 7, no. 6, p. 53, 2019. [12] ASTM-A1064-15, “Standard Specification for Carbon-Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete,” Annual Book of ASTM Standards American Society for Testing and Materials, Vol. 01.04, 2015. [13] ASTM International, “Standard Specification for Portland Cement,” Annual Book of ASTM Standards, vol. I, no. April, pp. 1–8, 2007. [14] ASTM Standard C33, “Standard Specification for Concrete Aggregates,” ASTM International, vol. i, no. C, p. 11, 2003. [15] ASTM-C494-17, “Standard Specification for Chemical Admixtures for Concrete,” Annual Book of ASTM Standards American Society for Testing and Materials, Vol. 04.01, pp. 1–10, 2018. [16] ACI-211.1, “Standard Practice for Selecting Proportions for Normal Heavyweight, and Mass Concrete,” Reported by ACI Committee 211, ACI Manual of Concrete Practice, American Concrete Institute, 2013., pp. 4–9. [17] ASTM-C143, “Standard Test Method for Slump of Hydraulic-Cement Concrete,” Annual Book of ASTM Standards American Society for Testing and Materials, Vol. 01.04, 2015., pp. 1–4. [18] ASTM-C192, “Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory,” Annual Book of ASTM Standards American Society for Testing and Materials, Vol. 01.04, 2015. [19] R. Zhang, A. Castel, and R. François, “Serviceability Limit State Criteria Based On Steel-Concrete Bond Loss for Corroded Reinforced Concrete in Chloride Environment,” Materials and Structures/Materiaux et Constructions, vol. 42, no. 10, pp. 1407–1421, 2009. [20] R. Zhang, A. Castel, and R. François, “Concrete Cover Cracking with Reinforcement Corrosion of RC Beam During Chloride-Induced Corrosion Process,” Cement and Concrete Research, vol. 40, no. 3, pp. 415–425, 2010. [21] R. Zhang, A. Castel, and R. François, “The Corrosion Pattern of Reinforcement and Its Influence On Serviceability of Reinforced Concrete Members in Chloride Environment,” Cement and Concrete Research, vol. 39, no. 11, pp. 1077–1086, 2009. [22] S. Ahmad, “Techniques for Inducing Accelerated Corrosion of Steel in Concrete,” Arabian Journal for Science and Engineering, vol. 34, no. 2, p. 95, 2009. [23] G. Malumbela, P. Moyo, and M. Alexander, “A Step Towards Standardising Accelerated Corrosion Tests On Laboratory Reinforced Concrete Specimens,” Journal of the South African Institution of Civil Engineering, vol. 54, no. 2, pp. 78–85, 2012. [24] S. A. Salih, M. S. Hassan, and J. Forth, “Modeling Time to Corrosion Initiation in High-Performance Ferrocement Exposed to Chlorides Environments هصلاخلا ,” Eng.& Tech. Journal, vol. 27, no. 1, 2009. [25] A. Kashi, A. A. Ramezanianpour, and F. Moodi, “Durability Evaluation of Retrofitted Corroded Reinforced Concrete Columns with FRP Sheets in Marine Environmental Conditions,” Construction and Building Materials, vol. 151, pp. 520–533, 2017. [26] H. Zhou, Y. Xu, Y. Peng, X. Liang, D. Li, and F. Xing, “Partially corroded reinforced concrete piers under axial compression and cyclic loading: An experimental study,” Engineering Structures, vol. 203, pp. 1–13, Jan. 2020. [27] M. S. Radhi, M. S. Hassan, and I. N. Gorgis, “Experimental Comparability Among Different Accelerated Reinforced Steel Concrete Corrosion Methods,” International Journal of Engineering & Technology, vol. 7, no. 4.20, p. 209, Nov. 2018. [28] M. S. Radhi, M. S. Hassan, and I. N. Gorgis, “Relationship Between Steel Mass Loss and Accelerated Corrosion Regimes in Reinforced Concrete Columns,” in 4th International Conference on Buildings, Construction and Environmental Engineering(BCEE4),İstanbul ,October 7-9, 2019,. [29] J. Joshi, H. C. Arora, and U. K. Sharma, “Structural performance of differently confined and strengthened corroding reinforced concrete columns,” Construction and Building Materials, vol. 82, pp. 287–295, May 2015. [30] J. H. Xie and R. L. Hu, “Experimental study on rehabilitation of corrosion-damaged reinforced concrete beams with carbon fiber reinforced polymer,” Construction and Building Materials, vol. 38, pp. 708–716, 2013. [31] N. Kisku, H. Joshi, M. Ansari, S. K. Panda, S. Nayak, and S. C. Dutta, “A critical review and assessment for usage of recycled aggregate as sustainable construction material,” Construction and Building Materials. 2017. [32] A. S. Rajput and U. K. Sharma, “Corroded reinforced concrete columns under simulated seismic loading,” Engineering Structures, vol. 171, no. January, pp. 453–463, 2018.
Statistics Article View: 569 PDF Download: 487