- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
PV/T Performance Evaluation as Electricity Generation and Hot Air Supplier for Fully and Partially Covered with PV Modules | ||
| Engineering and Technology Journal | ||
| Article 7, Volume 38, 7A, 2020, Pages 1001-1015 PDF (2.22 M) | ||
| Document Type: Research Paper | ||
| DOI: 10.30684/etj.v38i7A.559 | ||
| Authors | ||
| Jalal M. Jalil1; Ahmed A. Hussein2; Anwar J. Faisal3 | ||
| 1Electromechanical Eng. Dept., University of Technology - Iraq | ||
| 2Electromechanical Engineering Department, University of Technology-Iraq | ||
| 3Electromechanical Engineering Department, University of Technology-Iraq. | ||
| Abstract | ||
| The solar energy system is environmentally friendly and the utilization of photovoltaic thermal collectors, (PV/T) has attracted more attention, which directly converts solar radiation into electricity and thermal energy simultaneously. This study investigated the air biased Photovoltaic thermal hybrid solar collectors, (PV/T) trend for two cases, denominate case one (PV/T system fully covered with PV modules), and case tow (PV/T system partially covered with glass). The studied parameters were solar irradiance and the air mass flow rate. The investigation has been performed in terms of outlet air temperature, electrical power, thermal and electrical efficiencies. A numerical model was developed using the computational fluid dynamic program (CFD) and the results were compared with the experimental measurements that carried out from indoor conditions using a solar simulator. A good agreement has been achieved between experimental and numerical results. The performance of both cases one and case two concluded that the PV/T system should be operating at a moderate air flow rate of 0.013 kg/s, which is the best mass flow rate. In addition, it has been observed that for case tow the maximum outlet air temperature and electric powers were 44.3 oC and 26.6 W, respectively. For case one, thermal and electrical efficiencies were found 34% and 10%, respectively, based on the experimental data, while for case 2, the maximum thermal and electrical efficiencies were found to be 48.9 and 9.1%, respectively | ||
| Keywords | ||
| PV/T system; PV modules temperature; PV efficiency; thermal efficiency; Renewable energy; PV/T partially covered with PV | ||
| References | ||
|
[1] D. Atheaya, A. Tiwari, G. Tiwari, and I. Al-Helal, “Analytical characteristic equation for partially covered photovoltaic thermal (pvt) compound parabolic concentrator (cpc),” Solar Energy, vol. 111, pp.176–185, 2015. [2] F. Yazdanifard, E. Ebrahimnia-Bajestan, and M. Ameri, “Investigating the performance of a water-based photovoltaic/thermal (pv/t) collector in laminar and turbulent flow regime,” Renewable Energy, vol. 99, pp.295–306, 2016. [3] M. Tian, X. Yu, Y. Su, H. Zheng, and S. Riffat, “A study on incorporation of transpired solar collector in a novel multifunctional pv/thermal/daylighting (pv/t/d) panel,” Solar Energy, vol. 165, pp.90–99, 2018. [4] M. Farshchimonfared, J. Bilbao, and A. Sproul, “Channel depth, air mass flow rate and air distribution duct diameter optimization of photovoltaic thermal (pv/t) air collectors linked to residential buildings,”Renewable energy, vol. 76, pp. 27–35, 2015. [5] S. Bambrook and A. Sproul, “A solvable thermal circuit for modelling pvt air collectors,” Solar Energy, vol. 138, pp. 77–87, 2016. [6] A. Shahsavar and M. Ameri, “Experimental investigation and modeling of a direct-coupled pv/t air collector,” Solar Energy, vol. 84, no. 11,pp. 1938–1958, 2010. [7] F. Yazdanifard, E. Ebrahimnia-Bajestan, and M. Ameri,“Investigating the performance of a water-based photovoltaic/thermal (pv/t) collector in laminar and turbulent flow regime,” Renewable Energy, vol. 99, pp. 295–306, 2016. [8] Wu, Shuang-Ying, Chen Chen, and Lan Xiao, “Heat transfer characteristics and performance evaluation of water-cooled PV/T system with cooling channel above PV panel, ” Renewable Energy vol. 125, pp.936-946, 2018. [9] G. Tiwari, J. Yadav, D. Singh, I. Al-Helal, and A. M. Abdel-Ghany, “Exergoeconomic and enviroeconomic analyses of partially covered photovoltaic flat plate collector active solar distillation system,” Desalination,,vol. 367, pp. 186–196, 2015. [10] S. Tiwari, J. Bhatti, G. Tiwari, and I. Al-Helal, “Thermal modelling of photovoltaic thermal (pvt) integrated greenhouse system for biogas heating,” Solar Energy, vol. 136, pp. 639–649, 2016. [11] J. Tonui and Y. Tripanagnostopoulos, “Performance improvement of pv/t solar collectors with natural air flow operation,” Solar energy, vol. 82, no. 1, pp. 1–12, 2008. [12] H. B. Awbi, “Ventilation of building,” E & FN Spon, 1991. [13] J. P. Holman, “Heat transfer,” McGraw-Hill, Tenth Edition, New York, 2010. [14] Tiwari G. N., “Solar energy: fundamentals, design, modelling and Applications,” Alpha Science International, 1st Ed, 2002. [15] S. Kalogirou, “Solar energy engineering,” Elsevier, First Edition, 2009 [16] Dubey D., Solanki S.C. and Tiwari A., "Energy and exergy analysis of PV/T air collectors connected in series,” Energy and Buildings, Vol.41, PP.863-870, 2009. [17] B. Widyolar, L. Jiang, and R. Winston, “Spectral beam splitting in hybrid pv/t parabolic trough systems for power generation,” Applied Energy, vol. 209, pp. 236–250, 2018. [18] J. Allan, H. Pinder and Z. Dehouche, “Enhancing the thermal conductivity of ethylene-vinyl acetate(eva) in apho to voltaic thermal collector,” AIP Advances, vol.6, no.3, p.035011, 2016. | ||
|
Statistics Article View: 439 PDF Download: 326 |
||