Design of a Boost Converter with MPPT Algorithm for a PV Generator Under Extreme Operating Conditions

Hussein, Hussein A.; Mahdi, Ali J.; Abdul-Wahhab, Thamir M.

doi:10.30684/etj.v39i10.1888

	Design of a Boost Converter with MPPT Algorithm for a PV Generator Under Extreme Operating Conditions
Engineering and Technology Journal
Article 2, Volume 39, Issue 10, 2021, Pages 1473-1480 PDF (783.3 K)
Document Type: Research Paper
DOI: 10.30684/etj.v39i10.1888
Authors
Hussein A. Hussein^* ¹; Ali J. Mahdi²; Thamir M. Abdul-Wahhab³
¹Babylon Sewerage Directorate, Babylon Provincial Council, Babylon, Iraq.
²Electrical Engineering Dept., University of Karbala, Karbala, Iraq.
³Electrical Engineering Dept., University of Technology-Iraq, Alsina’a street, 10066 Baghdad, Iraq.
Abstract
Photovoltaic generators (PVGs) are one of the most popular renewable energy sources (RESs), which achieve 47% of RES in microgrids. The aim of this work is to design and simulate a PVG system with a rated power of about 1,621 kW at the standard test conditions (STC), i.e., 1,000 W/m² and 25ºC. The main components of the proposed PVG are 12 PV panels connected in series (the peak power of a PV panel at STC is about 135 W). A DC-DC boost converter is proposed for implementing the maximum power point tracking (MPPT) algorithm. The proposed MPPT algorithm is tested under extreme conditions; a wide range of change in temperature, irradiance, and load variations. The boost converter is designed to verify stable power flow from the PVG to the load. The calculated and the simulation results using MATLAB/Simulink are in good agreements and the maximum efficiency of the implemented MPPT algorithm is about 99%.
Highlights
The boost converter considered a variable voltage of PV array under weather conditions. The designed converter is able to deliver power to grid with the efficiency of 96%. The maximum efficiency of the MPPT is about 99%, tested under extreme conditions.
Keywords
PVG model; Estimating maximum power point (MPP); Maximum power point tracking (MPPT); Boost converter design

References
[1] A. J. Mahdi, Design And Performance Analysis Of An On-Grid Photovoltaic Power System Under Iraqi Solar Circumstances, J. Eng. Sustain. Dev., 21, 4, 2017, 46–57. [2] A. J. Mahdi, S. Fahad, and W. Tang, An Adaptive Current Limiting Controller for a Wireless Power Transmission System Energized by a PV Generator, Electronics, 9, 10, 2020, 1648. [3] H. Mamur and R. Ahiska, Application of a DC–DC boost converter with maximum power point tracking for low power thermoelectric generators, Energy Convers. Manag., 97, 2015, 265–272. [4] B. Nayak, A. Mohapatra, and K. B. Mohanty, Selection criteria of dc-dc converter and control variable for MPPT of PV system utilized in heating and cooking applications, Cogent Eng., 4, 1, 2017,1363357. [5] A. Pradhan and B. Panda, A simplified design and modeling of boost converter for photovoltaic sytem, Int. J. Electr. Comput. Eng., 8, 1, 2018,141. [6] A. Chouder, S. Silvestre, N. Sadaoui, and L. Rahmani, Modeling and simulation of a grid connected PV system based on the evaluation of main PV module parameters, Simul. Model. Pract. Theory, 20, 1, 2012, 46–58. [7] A. Guerra Vega, Designing a Solar PV System to Power a Single-Phase Distribution System, 2019. [8] S. B. Kjær, Design and control of an inverter for photovoltaic applications. Institute of Energy Technology, Aalborg University, 2005. [9] H. Al-Bahadili, H. Al-Saadi, R. Al-Sayed, and M. A.-S. Hasan, Simulation of maximum power point tracking for photovoltaic systems, in 2013 1st International Conference & Exhibition on the Applications of Information Technology to Renewable Energy Processes and Systems, 2013, 79–84. [10] D. Choudhary and A. R. Saxena, Incremental conductance MPPT algorithm for PV system implemented using DC-DC buck and boost converter, Int. J. Eng. Res. Appl, 14, 2014, 123–132. [11] O. P. Mahela and A. G. Shaik, Comprehensive overview of grid interfaced solar photovoltaic systems, Renew. Sustain. Energy Rev., 68, 2017, 316–332. [12] S. Fahad, A. J. Mahdi, W. H. Tang, K. Huang, and Y. Liu, Particle swarm optimization based dc-link voltage control for two stage grid connected pv inverter, in 2018 International Conference on Power System Technology (POWERCON), 2018, 2233–2241. [13] P. W. Chan, DC-DC boost converter with constant output voltage for grid connected photovoltaic application system, in Industrial Electronic Seminar, 2010. [14] M. K. Kazimierczuk, Pulse-width modulated DC-DC power converters. John Wiley & Sons, 2015. [15] I. Batarseh and A. Harb, Power Electronics. Springer, 2018.
Statistics Article View: 995 PDF Download: 1,690