- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Effect of the type of reinforcing for Hardness properties for (Thermoset – fibers) composite . | ||
| Journal of University of Anbar for Pure Science | ||
| Article 23, Volume 12, Issue 1, 2018, Pages 122-130 PDF (475.1 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.37652/juaps.2022.171669 | ||
| Authors | ||
| Majeed SHihab Ahmed; Faik Hammad Anter | ||
| Department of physics، College of science، University of Anbar . Anbar – Iraq | ||
| Abstract | ||
| This research included preparation of two types of fiber composites and the the basis as ato break the stereotypes and manual volumetric rate of 25% . The characterization of the fiber is divided into two types:Overlapping material composed of epoxy resin as a subsidized two layers and four layers , six layers of fiber glass basis of the type (E-Glass) is woven mat.Overlapping material composed of epoxy as supported by two layers and four layers , six layers of caors rock wool fibers basis . In this paper the hardness characteristic study of the above complexes in natural conditions and after immersion normal water for different time periods is (5,10,15) days at room temperature . The results showed the process that the value of surface hardness for both types of specimens in natural conditions increases with the number of layers of reinforcement and that the value of the complexes fiberglass higher than the value of the complex rock wool fibers , after immersion the samples with water usual noticed that the surface hardness decreases with increasing duration of water immersion and with increasing number of reinforcement layers and both types of complexes , but their value in the complexes, fiberglass largest of its value for the characterization of rock wool fibers . | ||
| Keywords | ||
| متراکبات الألیاف; القولبة الیدویة; راتنج الایبوکسی; الألیاف الزجاجیة نوع E–Glass | ||
| References | ||
|
1. M. O. W. Rechadson, "Polymer Engineering Composites"، Applied science pud LTD، London 1977.
2-ا. د. کورکیس عبدأل آدم، د. حسین علی کاشف الغطاء، "تکنولوجیا البولیمرات" ،جامعة ألبصره، کلیة العلوم، 1983. 3.M.Garyson، " Encyclopedias of composite materials and components", John Wiley and sons, Newyork، 1993 .
4. L.H. Sperling، " Introduction to physical polymer science ", Lehigh university, John Wiley and sons, Inc، USA, 2006.
5-فریربلیمر, ترجمة د. صلاح محسن علیوی " أساسیات علم البولیمر" قسم الکیمیاء, کلیة العلوم، جامعة الموصل, 1971. 6. M.A. Meyers and k.k. Chawla، "Mechanical behavior of materials "، Newjersy prentice Hall، 1999 .
7. J.G. Morley، "High performance of fiber composites "،university of Nottingham، UK، 1987.
8.A.M . Hindeleh and sh. Abdo, "Relationship between Crystalline Structure and mechanical Properties in Kevlar ® 9 fibers", Journal of polymer communication ، vol. 30, N: 6، pp (184-186)، 1989 .
9.Microsoft، Encarta، " composite materials Encyclopedia "، 2000.
10. W. Bolton, Engineering material Technology"، Third Edition, Newyork, 1998.
11.R . Mibly، " plastic Technology "، MC Graw – Hill، Inc، USA، 1973.
12. A. C. Grag and Y . W . Mai، " Failur Mechanism in Toughned Epoxy Resins– Areview ", Composites Science and Technology، vol . 31، NO. 3، pp .(179 -223)، 1988. .
13.L . Hnery and k . kevitteg، " Hand book of Epoxy Resin "، MC – Graw Hall، 1967..
14. A. D. Car wad and Lawrence، " Analysis and performance of fiber composites "، John and sons, USA، 1980..
15.W. Yang, W. Shi, Z. M. Li, B. H. Xie and J. M. Feng, "Mechanical Properties of Glass Bead-Filled Linear Low Density Polyethylene", J. of Elastomer and plastic ، vol. 36،No.3, pp(251 -265)، 2004.
16-نور طیب الذهبی، " دراسة الخواص الفیزیائیة لمتراکبات بولیمریة "، رسالة ماجستیر، کلیة العلوم، الجامعة المستنصریة، 2002. 17.Q . A. Hamad AL – Jubohri, "Studying Mechanical and physical properties for polymer matrix composite matrix reinforced by fibers and particles", Msc .Thesis، Material Engineering، 2008.
18. A. Apicella، C. Miqliaresi، C. Nicodemo, L. Nicolais, I. Lucerino،and S. Roccotelli "،Composites ", vol. 13، no: 4, pp (406 -410), 1982.
19-بان مازن الشابندر، " دراسة الخواص الکهربائیة لمتراکب الایبوکسی المدعم بالألیاف الزجاجیة"، رسالة ماجستیر، جامعة بغداد، کلیة العلوم، 2005. | ||
|
Statistics Article View: 383 PDF Download: 311 |
||