Thermoelectric Generators as a Heat Recovery System for Exhaust Gases of Vehicles Driving at Low Speeds

Al-Janabi, A.; Al Salmi, O.; Al Subhi, E.; Al Hadhrami, A.

doi:10.30684/etj.2022.134206.1253

	Thermoelectric Generators as a Heat Recovery System for Exhaust Gases of Vehicles Driving at Low Speeds
Engineering and Technology Journal
Article 17, Volume 41, Issue 1, 2023, Pages 185-195 PDF (1.43 M)
Document Type: Review Paper
DOI: 10.30684/etj.2022.134206.1253
Authors
A. Al-Janabi^* ¹; O. Al Salmi²; E. Al Subhi²; A. Al Hadhrami²
¹College of Engineering, Mechanical &amp; industrial Department, Sultanate of Oman
²College of Engineering, Mechanical & industrial Department, P. O. Box. 33, Postal Code: 123 Al-Khoud, Sultanate of Oman.
Abstract
To save the environment and utilize the waste heat associated with exhaust gases of internal combustion engines, it is crucial to design an efficient system that can recover this heat loss and convert it into useful energy. This study is devoted to developing, through an experimental approach, a practical technical solution to minimize the waste heat of the exhaust gases and convert it into a source of power for further applications in the vehicle. Six thermoelectric generators (TEG1-1263-4.3) were attached to the exhaust pipe in an arrangement of three connected in parallel and three connected in series. The thermoelectric generators were in a square shape of size 30 mm x 30 mm, and operated at a maximum temperature of 320. The experiments were conducted for a vehicle speed limit between (10 km/h - 60 km/h). It has been found that at a vehicle speed of 55 km/h, the exhaust pipe surface temperature reached approximately 116^oC. For six models of TEGs, the output voltage was 4.13 volts. And the system efficiency was found to vary between 3.6% -15.9%, depending on the surface temperature of the exhaust pipe, i.e., the surface temperature that is in contact with the hot side of the thermoelectric generators. Such outputs refer to the efficiency of TEGs to be used as a heat recovery system. Furthermore, the produced power can be used for feeding other applications within the vehicle, such as using a small fridge for a cooling process.
Highlights
Thermoelectric generators (TEGs) were directly recovering the waste heat from the exhaust and converting it into power. The TEGs generate power when there is a temperature difference between the hot and cold sides of the exhaust pipe. EGs waste heat recovery system (WHRS) produced 4.6 W that was used for the cooling process within the vehicle. TEGs waste heat recovery system achieved a real thermal efficiency of 15.9%, closer to ideal thermal efficiency. Implementing TEGs WHRS provides a higher potential to be a successful low-weight heat recovery system that could be installed on the vehicles
Keywords
Heat recovery; Exhaust gases; Thermoelectric generators; Internal combustion engines; Waste heat

References
[1] S. Kim, S. Park, S. Kim, S. H. Rhi, A thermodynamics generator using engine coolant for light-duty internal combustion engine-powered vehicles, J. Electron. Mater. 40 (2011) 812-816. [2] B. Orr, A. Akbarzadeh, Prospects of waste heat recovery and power generation using thermoelectric generator, Energy Procedia. 110 (2017) 110 250-255. [3] J. Gao, H. Chen, G. Tian, C. Ma, F. Zhu, An analysis of energy flow in a turbocharged diesel engine of a heavy truck and potentials of improving fuel economy and reducing exhaust emissions, Energy Conversion Management. 184 (2019) 456-65. [4] M. A. Chatzopoulou, C. N. Markides, Thermodynamic optimization of a high-electrical efficiency integrated internal combustion engine Organic Rankine Cycle combined heat and power system, Appl Energy. 226 (2018) 1229-1251. [5] S. Pradhan, A. Thiruvengadam, P. Thiruvengadam, M. Besch, Investigating the potential of waste heat recovery as a pathway for heavy-duty exhaust aftertreatment thermal management, SAE Technical Paper, 2015. [6] W. Gu, Y. Weng, Y. Wang, B. Zheng, Theoretical and experimental investigation of an organic Rankine cycle for a waste heat recovery system. Proc. Inst. Mech. Eng., Part A: J. Power Energy. 223 (2009) 523-533. [7] P.S. Bundela, C. Vivek, Sustainable development through waste heat recovery, American Journal of Environmental Sciences. 6 (2010) 83-89. [8] A. Domingues, H. Santos, M. Costa, Analysis of vehicle exhaust waste heat recovery potential using a Rankine cycle, Energy. 49 (2013) 71-85. [9] V. Magar, V. Bhosale, Waste heat recovery using nanofluid charged heat pipe heat exchanger (HPHE) for variable Source, International Engineering Research Journal. 188 (2015) 188-194. [10] G. S. Wahile, P. D. Malwe, A. V. Kolhe, Waste heat recovery from exhaust gas of an engine by using a phase change material. Materials Today: Proceedings, (2020) 2101-2107. [11] J. Ringler, M. Seifert, V. Guyotot, W. Hübner, Rankine cycle for waste heat recovery of IC Engines, SAE International Journal of Engines, 2 (2009) 67-76. [12] B. Singh, B. Orr, M. F. Remeli, L. Tan, A. Date, Akbarzadeh A., Power production by thermoelectric cells using engine exhaust gas, 11^th International Heat Pipe Symposium, Beijing, China, 2013. [13] Remeli M. F., Kiatbodin L., Singh B., Verojporn K., Date A., Akbarzadeh, A., Power generation from waste heat using heat pipe and Thermoelectric generator, Energy Procedia, 75(2015) 645-650. [14] J. Merkisz, O. Fuc, P. Lijewski, A. Ziolkowski, K. T. Wojciechowski, The analysis of exhaust Gas thermal energy recovery through a TEG generator in city traffic conditions reproduced on a dynamic engine test bed, J. Electron. Mater. 44 (2015) 1704-1715. [15] Y. Yaakob, A. Fahmi, H. Ghafar, D. Ibrahim, H. Moria, The waste heat recovery for power generation from automotive exhaust using thermoelectric cell (TEC), Journal of Physics: Conference Series. 1349 (2019) 1-7. [16] M. Q. Khan, S. Malarmannan., G. Manikandaraja., Power generation from waste heat of vehicle exhaust using thermoelectric generator: A review, 2^nd International Conference on Advances in Mechanical Engineering (ICAME), 402, 1-9, 2018. [17] S. Rana, B. Orr, A. Iqbal, L. C. Ding, A. Akbarzadeh, A. Date, Modeling and optimization of low-temperature waste heat thermoelectric generator system, Energy Procedia. 110 (2017) 196- 201. [18] N. Kumar, V. Setia, S. K. Patel, S. Upadhyay, S. Chauhan, P. Bajpai, Analysis of energy generation from exhaust of automobile using Peltier (thermoelectric generator), International Journal of Trend in Scientific Research and Development (IJTSRD). 3 (2019) 749-751 [19] S. Belgaonkar, A. Dandekar, R. Patil, A review of thermoelectric generator and cooler for an automobile, Gis Science Journal. 8 (2021) 973-979. [20] Information, N. C. Total registered vehicles by their color, engine capacity, and weight. Monthly Statistical Bulletin, (2021) 32-33. [21] LaGrandeur J., Crane B., Eder A., Vehicle fuel economy improvement through thermoelectric waste heat recovery, DEER Conference, Chicago, IL, USA, 2005. [22] I. P. Kandylas, A. M. Stamatelos, Engine exhaust system design based on heat transfer computation. Energy Conversion and Management. 40 (1999) 1057-1072. [23] Cengel Y., Ghajar A. Heat and mass transfer: Fundamentals and Applications, 6^th ed., Mc Graw Hill, 2020. [24] TEG1-1263-4.3 - Thermoelectric Generator. (2022, January 18). Thermoelectric Generator. https://thermoelectric-generator.com/product/teg1-1263-4-3. [25] Y. Y. Hsiao, W. C. Chang, S. L. Chen, A mathematic model of thermoelectric module with applications on waste heat recovery from automobile engine, Energy. 35 (2010) 1447-1454. [26] Moran M. J., Shapiro H. N., Boettner D. D., BAILEY B. B., Fundamentals of Engineering Thermodynamics, 8^th ed., Wiley, 2014.
Statistics Article View: 763 PDF Download: 425