- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Finite Element Analysis of the Rake Angle Effects on Residual Stresses in a Machined Layer | ||
| Engineering and Technology Journal | ||
| Volume 25, Issue 1, 2007, Pages 36-48 PDF (293.3 K) | ||
| DOI: 10.30684/etj.25.1.6 | ||
| Author | ||
| Maan Aabid Tawfiq | ||
| Abstract | ||
| In this paper, a plane strain Finite Element Method is developed and applied to model and simulate the orthogonal metal cutting of (AISI 1045 St) with continuous chip formation. Seven sets of simulation results for cutting with rake angles (-15o, -10o, -5o, 0o, 5o, 10 o and 15o), are summarized and compared to analyze their effects in the cutting process in steady state condition. Simulation results of the residual stresses below the machined layer are presented and compared with other papers in the literature and showed good agreement. Simulation results offer an insight into residual stresses through different values of rake angles. Based on simulation results, characteristics of residual stress distribution can be controlled by optimizing the rake angle. The simulated results show that for positive rake angles and position, the zero of maximum effective stress is found to be at (0.04) mm beneath the work piece surface, while for negative rake angles, the position of maximum effective stress is changed to be directly on the workpiece surface. | ||
|
Statistics Article View: 111 PDF Download: 152 |
||