- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
CFD analysis of vertical axis wind turbine with modified blades for deployment in Ilorin, Kwara State, Nigeria | ||
| Al-Qadisiyah Journal for Engineering Sciences | ||
| Article 13, Volume 18, Issue 1, March 2025, Pages 83-91 PDF (13.37 M) | ||
| Document Type: Research Paper | ||
| DOI: 10.30772/qjes.2024.151245.1293 | ||
| Authors | ||
| Olalekan Adebayo Olayemi* 1; Tomisin Favour Ajide1; Abdulbaqi Jinadu1; Leke Thaddeus Oladimeji1; David Omotayo Olayemi2; Taofiq Omoniyi Amoloye1; Jumoke M. Bambe1 | ||
| 1Department of Aeronautical and Astronautical Engineering, Faculty of Engineering and Technology, Kwara State University, Malete, Nigeria | ||
| 2Department of Electrical and Electronics Engineering, Faculty of Engineering and Technology, Federal University Oye-Ekiti, Nigeria | ||
| Abstract | ||
| Researchers and the energy industry are currently focusing their efforts on optimizing the effectiveness of vertical-axis wind turbines (VAWT) to cut down on the reliance on energy supply from fossil fuels which releases gases that are toxic to the environment. As such, several methods have been applied, including increasing the velocity and modification of both the trailing and leading edges of the aerofoil. In the present investigation, numerical studies of the flow on the wind turbine blades with a NACA0015 airfoil section equipped with and without tubercles on the trailing edge were conducted using ANSYS Fluent. A computational domain of 2000mm by 35000mm was employed with the turbulence model. This two-dimensional computational fluid dynamics (CFD) analysis was performed with Ilorin, Kwara State, Nigeria wind data that was received from the Nigeria Meteorological Agency (NIMET). The modified blade with a wavelength of 0.09m and an amplitude of 0.004m is seen to have a better thrust than the unmodified blade. It produced a thrust of 118N for a tip-speed ratio (TSR) of 4.0 compared to 109N of the unmodified blade at the same TSR and that of the modified blade (1) which attains 107N. Also, its coefficient of performance is 5% and 6% higher than that of the straight and modified blades (1) respectively,suggest that an increase in the tubercle’s wavelength and amplitude increased the maximum thrust. | ||
| Keywords | ||
| CFD; Wind turbines; Tubercle; Energy source; Ansys; NACA0015 | ||
| References | ||
|
[1] Kumar, V. V., & Shah, D. A. (2017). Application of Tubercles in Wind Turbine Blades: A Review. Applied Mechanics and Materials, 867, 254–260. https://doi.org/10.4028/www.scientific.net/AMM.867.254
[2] Yilmaz, O. (2023). Low-speed , low induction multi-blade rotor for energy efficient small wind turbines. Energy, 282(July), 128607. https://doi.org/10.1016/j.energy.2023.128607
[3] UN. (2024). Causes and Effects of Climate Change. United Nation, Climate Action. https://www.un.org/en/climatechange/science/causes-effects-climate-change
[4] Zhao, Z., Wang, D., Wang, T., Shen, W., Liu, H., & Chen, M. (2022). Review article A review : Approaches for aerodynamic performance improvement of lift-type vertical axis wind turbine. 49(October 2021).
[5] Lohry, M. W., Clifton, D., & Martinelli, L. (2012). Characterization and Design of Tubercle Leading-Edge Wings. 1–11.
[6] Pan, J., Ferreira, C., & van Zuijlen, A. (2024). Performance analysis of an idealized Darrieus–Savonius combined vertical axis wind turbine. *Wind Energy*. https://doi.org/10.1002/we.2904
[7] Nagare, P., & Kale, P. (2015). Vertical Axis Wind Turbine. 0–5.
[8] Zhang, J. (2004). Numerical Modeling of Vertical Axis Wind Turbine (VAWT) Master thesis.
[9] Schubel, P. J., & Crossley, R. J. (2012). Wind Turbine Blade Design Review. Wind Engineering, 36(4), 365–388. https://doi.org/10.1260/0309-524X.36.4.365
[10] Elgendi, M., AlMallahi, M., Abdelkhalig, A., & Selim, M. Y. E. (2023). A review of wind turbines in complex terrain. International Journal of Thermofluids, 17, 100289. https://doi.org/10.1016/j.ijft.2023.100289
[11] Uchida, T., Taniyama, Y., Fukatani, Y., Nakano, M., Bai, Z., Yoshida, T., & Inui, M. (2020). A New Wind Turbine CFD Modeling Method Based on a Porous Disk Approach for Practical Wind Farm Design. Energies, 13(12), 3197. https://doi.org/10.3390/en13123197
[12] Saravanan, M. & Muthurajan, K.G.. (2018). Design and Analysis of Vertical Axis Wind Turbine Blade Made of GFRP Composite Material Using Ansys. International Journal of Research and Analytical Reviews, 5(4), 544–550. e ISSN 2348 –1269, Print ISSN 2349-5138
[13] Karwa, N., & Barve, S. B. (2021). Design , Modelling and Analysis of Savonius Vertical Axis Wind Turbine. 351–357.
[14] Hameed, M. S., & Afaq, S. K. (2013). Design and analysis of a straight bladed vertical axis wind turbine blade using analytical and numerical techniques. 57, 248–255. https://doi.org/10.1016/j.oceaneng.2012.09.007
[15] Rezaeiha, A., Kalkman, I., & Blocken, B. (2017). Effect of pitch angle on power performance and aerodynamics of a vertical axis wind turbine. Applied Energy, 197, 132–150. https://doi.org/10.1016/j.apenergy.2017.03.128.
[16] Joo, S., Choi, H., & Lee, J. (2015). Aerodynamic characteristics of two-bladed H-Darrieus at various solidities and rotating speeds. 90(October), 439–451.
[17] Rahimp, M. T. B., Allet, A., & Paraschivoiu, I. (1995). Aerodynamic Analysis Models for Vertical-Axis Wind Turbines. 2(1), 15–21.
[18] Mahmood, M., Bhutta, A., Hayat, N., Farooq, A. U., Ali, Z., Jamil, S. R., & Hussain, Z. (2012). Vertical axis wind turbine – A review of various configurations and design techniques. Renewable and Sustainable Energy Reviews, 16(4), 1926–1939. https://doi.org/10.1016/j.rser.2011.12.004.
[19] Feng, F., Zhao, S., Qu, C., Bai, Y., Zhang, Y., & Li, Y. (2018). Research on Aerodynamic Characteristics of Straight-Bladed Vertical Axis Wind Turbine with S Series Airfoils. International Journal of Rotating Machinery, 2018, 1–13. https://doi.org/10.1155/2018/8350243
[20] Gosselin, R., Dumas, G., & Boudreau, M. (2013). Parametric study of H-Darrieus vertical-axis turbines using uRANS simulations.
[21] Howell, R., Qin, N., Edwards, J., & Durrani, N. (2010). Wind tunnel and numerical study of a small vertical axis wind turbine. Renewable Energy, 35(2), 412–422. https://doi.org/10.1016/j.renene.2009.07.025
[22] Nguyen, L., & Metzger, M. (2017). Optimization of a vertical axis wind turbine for application in an urban / suburban area. 043302. https://doi.org/10.1063/1.4994574
[23] Sathish, T. (2021). Fluid flow analysis of composite material-based wind turbine blades using Ansys. International Journal of Ambient Energy, 42(12), 1396–1399. https://doi.org/10.1080/01430750.2019.1608861.
[24] Blackwell, B. F., Sheldahl, R. E., & Feltz, L. V. (1976). Wind Tunnel Performance Data for the Darrieus Wind Turbine with NACA 0 < Blades. May.
[25] Durrani, N., & Mian, H. H. (2011). A detailed Aerodynamic Design and analysis of a 2D vertical axis wind turbine using sliding mesh in CFD. January. https://doi.org/10.2514/6.2011-541
[26] Dominy, R., Lunt, P., Bickerdyke, A., & Dominy, J. (2007). Self-starting capability of a Darrieus turbine. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 221(1), 111-120.
[27] Castelli, M. R., Betta, S. De, & Benini, E. (2012). Effect of Blade Number on a Straight-Bladed Vertical-Axis Darreius Wind Turbine. 6(1), 68–74.
[28] Zhao, Z., Wang, R., & Shen, W. (n.d.). (2018). applied sciences Variable Pitch Approach for Performance Improving of Straight-Bladed VAWT at Rated Tip Speed Ratio. https://doi.org/10.3390/app8060957
[29] Brusca, S., Lanzafame, R., & Messina, M. (2015). Design and performance of a straight-bladed darrieus wind turbine Design and Performance of a Straight-Bladed Darrieus Wind Turbine. September.
[30] Kaviti, A., Shukla, V., & Kumar, A. (2017). Performance evaluation of profile modifications on straight-bladed vertical axis wind turbine by energy and Spalart Allmaras models Performance evaluation of pro fi le modi fi cations on straight-bladed vertical axis wind turbine by energy and Spalart All. Energy, 126(August 2018), 766–795. https://doi.org/10.1016/j.energy.2017.03.071
[31] Wafula, D., Wang, C., Wei, Y., Angelo, L., & Danao, M. (2014). Journal of Wind Engineering In fl uence of operating conditions on unsteady wind performance of vertical axis wind turbines operating within a fl uctuating free-stream : A numerical study. 135, 76–89
[32] Biadgo, A. M., Simonovic, A., Komarov, D., & Stupar, S. (2013). Numerical and Analytical Investigation of Vertical Axis Wind Turbine. 49–58.
[33] Aziz, P. D. A., Mohamad, A. K. R., Hamidon, F. Z., Mohamad, N., Salleh, N., & Yunus, N. M. (2014). A Simulation Study on Airfoils Using VAWT Design for Low Wind Speed Application. August, 1–6. https://doi.org/10.1109/ICE2T.2014.7006228
[34] Zhu, H., Hao, W., Li, C., Ding, Q., & Wu, B. (2018). A critical study on passive flow control techniques for straight-bladed vertical axis wind turbine. Energy, 165, 12–25. https://doi.org/10.1016/j.energy.2018.09.072
[35] Sun, X., & Zhou, D. (2022). Review of Numerical and Experimental Studies on Flow Characteristics around A Straight-bladed Vertical Axis Wind Turbine and Its Performance Enhancement Strategies. Archives of Computational Methods in Engineering, 29(3), 1839–1874. https://doi.org/10.1007/s11831-021-09640-4
[36] Prakash, P., Nair, A., Manoj, J., Thoppil, T. M., & Mishra, N. (2021). Parametric Study of Leading-Edge Tubercle: Bio-inspired Design of Darrieus Vertical Axis Wind Turbine (pp. 243–251). https://doi.org/10.1007/978-981-16-1119-3_22
[37] Mishra, N., Prakash, P., Gupta, A. S., Dawar, J., Kumar, A., & Mitra, S. (2022). Numerical and Experimental Investigations on a Bio-Inspired Design of Darrieus Vertical Axis Wind Turbine Blades With Leading Edge Tubercles (pp. 211–224). https://doi.org/10.4018/978-1-7998-8561-0.ch010
[38] Sridhar, S., Joseph, J., & Radhakrishnan, J. (2022). Implementation of tubercles on Vertical Axis Wind Turbines (VAWTs): An Aerodynamic Perspective. Sustainable Energy Technologies and Assessments, 52, 102109. https://doi.org/10.1016/j.seta.2022.102109
[39] Bai, C., Lin, Y., Lin, S., Wang, W. (2015). Computational fluid dynamics analysis of the vertical axis wind turbine blade with tubercle leading edge Computational fluid dynamics analysis of the vertical axis wind turbine blade with tubercle leading edge. 033124, 0–14. https://doi.org/10.1063/1.4922192
[40] Lin, S.-Y., Lin, Y.-Y., Bai, C.-J., & Wang, W.-C. (2016). Performance analysis of vertical-axis-wind-turbine blade with modified trailing edge through computational fluid dynamics. Renewable Energy, 99, 654–662. https://doi.org/10.1016/j.renene.2016.07.050
[41] Siddiqui, M.-S., Rasheed, A., Kvamsdal, T., & Tabib, M. (2015). Effect of Turbulence Intensity on the Performance of an Offshore Vertical Axis Wind Turbine. Energy Procedia, 80, 312–320. https://doi.org/10.1016/j.egypro.2015.11.435
| ||
|
Statistics Article View: 400 PDF Download: 3,573 |
||