- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
A Comparative Evaluation of Marginal and Internal Fitness of Zirconia Monolithic Crown Fabricated with Different CAD\CAM Systems: (In Vitro Study) | ||
| Tikrit Journal for Dental Sciences | ||
| Volume 12, Issue 1, June 2024, Pages 1-10 PDF (269.56 K) | ||
| DOI: 10.25130/tjds.12.1.1 | ||
| Authors | ||
| Tasneem K. Assi* ; Adel F. Ibraheem | ||
| Department of Conservative Dentistry, College of Dentistry, University of Baghdad, Iraq. | ||
| Abstract | ||
| The precision of computer-aided design/computer-aided manufacturing (CAD/CAM) systems is reliant upon their technical attributes and reliability in producing the designated restorations. The evaluation of this precision is primarily conducted through the examination of the marginal and internal fitness of said restorations. Consequently, the objective of this research endeavor was to analyze and compare the marginal and internal fitness of zirconia crowns fabricated using various CAD/CAM systems. The samples were categorized into four groups, each consisting of 10 samples, based on the specific CAD/CAM equipment employed for crown fabrication as follows: Group I fabricated using Sirona CAD\\CAM milling machine, Group II fabricated using Dentium CAD\\CAM machine, Group III fabricated using XTCERA CAD\\CAM machine and Group IV fabricated using IMES-ICORE CAD\\CAM machine. Tooth preparation done following the guidelines recommended by KATANA TM Zirconia (Kurary Noritake Dental Inc., Japan). To ensure standardization, one CAD/CAM program designed parameters was selected to be used for all CAD/CAM machines. Cement thickness was directly measured using sectioning technique to assess the crown's internal and marginal fitness. After performing sectioning, measurements were conducted using a digital microscope with a magnification of 230x. Eleven predetermined measuring locations were selected for each sample, representing four distinct areas: two marginal points, two chamfer points, four axial points, and three occlusal points. Results showed that none of four CAD\\CAM machines tested was able to accurately reproduce the designed cement space parameter except Group I (Sirona) showed the closest results. As a conclusion, no CAD\\CAM system is 100% accurate however, crowns fabricated using Sirona CAD\\CAM milling machine showed the closest recordings to selected parameters among other CAD\\CAM milling machines tested. | ||
| Keywords | ||
| CAD\CAM zirconia marginal gap internal ga | ||
|
Statistics Article View: 486 PDF Download: 228 |
||