Finite Element Prediction of Temperature Rise Distributionin Turning Process of AISI 1045 Carbon Steel

L, Rana; J.Yaseen, Sana; A. Kawi, Assmaa

	Finite Element Prediction of Temperature Rise Distributionin Turning Process of AISI 1045 Carbon Steel
Thi-Qar University Journal for Engineering Sciences
Article 1, Volume 2, Issue 2, 2011, Pages 52-69
Authors
Rana L; Sana J.Yaseen; Assmaa A. Kawi
Abstract
In this paper the code DEFORM-3D V6.1 was used to perform a finite element analysis simulating the turning process of AISI 1045 carbon steel. A series of thermal simulations have been performed, the value and location of maximum temperature have been determined. The comparison of the simulations with earlier works gave promising trend for the presented work with a maximum percentage of error 3.23%. The results of this work show that the maximum temperature exists in the vicinity of the cutting edge. i.e. in the tool-chip contact and then starts cooling immediately when the tool crosses this region. Besides the maximum temperature in the tool-chip interface increases as the cutting time increases until the process reaches the steady-state condition where the temperature is alternating around the mean temperature. Finally the behavior of temperature differs in value and distribution for the same location and time (same boundary conditions) in the cutting direction with the change in depth of cut where the maximum temperature occurs at maximum depth of cut

Statistics Article View: 217 PDF Download: 47