Effect of Shaft Misalignment on The Stresses Distribution of Spur Gears

Aziz Ameen, Hani

doi:10.30684/etj.28.7.5

	Effect of Shaft Misalignment on The Stresses Distribution of Spur Gears
Engineering and Technology Journal
Article 1, Volume 28, Issue 7, 2010, Pages 1321-1339 PDF (504.5 K)
DOI: 10.30684/etj.28.7.5
Author
Hani Aziz Ameen
Abstract
Shaft misalignment is considered as one of the common repeated problems in most rotating machineries , which leads to generate vibrations and extra dynamic loads on transmitting gears teeth, also leads to non- uniformity in distribution of applied load along the meshing tooth face by being concentrated on one side of tooth face. The present work concentrated on the analysis of stresses generated on transmitting gear tooth, also studied the effect of misalignment angle on stress distribution and its concentration. This is important for the gear design and those who works in gear maintenance , because fracture is expected to initiate and propagate at locations of stress concentration . ANSYS program using finite element technique had been used, as this program is efficient and accurate tool in stress analysis, especially for complicated shapes. Gear tooth model had been analyzed using finite element method in three dimensions. After calculating transmitted load and dynamic load, misalignment angle had been changed from (0°,0.2°,0.3°,0.4°,0.5°) then its effect on distribution of applied load had been calculated. The finite element program (ANSYS) had been executed for cases of misalignment angle (0°,0.2°,0.3°,0.4°,0.5°). The results showed clearly, that the stresses distribution and its concentration on tooth changed with misalignment angle and the equivalent stress is direct proportional with the misalignment angle. According to the values of generated stresses, the tooth fracture can be predicted
Keywords
Machine Design; Gear Design; Finite element method; Stresses Analysis; ANSYS software; Misalignment

Statistics Article View: 369 PDF Download: 255