- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
The Effect of Area Reduction of Forward Die on the Combined Forward- Backward Extrusion Process | ||
| ALNAHRAIN JOURNAL FOR ENGINEERING SCIENCES | ||
| Article 1, Volume 12, Issue 2, 2009, Pages 108-121 | ||
| Authors | ||
| Ali Hassan Saleh; Muhsin Jabur Jweeg; Jamal Hussien Muhamed | ||
| Abstract | ||
| The effect of reduction area for flat and conical dies in forward-backward extrusion process was investigated experimentally using flat punches with three reduction areas (0.305,0.444,0.605), 0.444 with cone angles (60o,90o,120o) and polygonal punches (hexagonal and square).Three reduction areas of dies (0.395, 0.555, 0.691) are used. The results show that the extrusion load is effected with reduction area of flat dies more than conical dies when using cone and flat punches while the reduction area of conical dies affected with square punch more than hexagonal punch and this result was inversed with flat dies. The relative extrusion pressure P/Y ̅ increases when the reduction area of conical and flat dies increases too for all punches, but this result contrasts with the square punch at conical dies.The less value of max. stress was found with cone punch of prism angle 120o among cone punches for conical dies except the die of reduction area (0.555) and the cone punch of 90o prism angle gave less max. stress with all flat dies. Flat punch of reduction area (0.444) among the flat punches gave less value of max. stress with all conical dies and flat die of reduction area (0.691). | ||
| Keywords | ||
| Extrusion; Die | ||
|
Statistics Article View: 168 PDF Download: 56 |
||