- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
The effect of drawing ratio in deep drawing process on thickness distribution along the cup | ||
| Al-Rafidain Engineering Journal (AREJ) | ||
| Article 15, Volume 18, Issue 4, 2010, Pages 81-86 PDF (0 K) | ||
| DOI: 10.33899/rengj.2010.31547 | ||
| Author | ||
| Dr.A. D.Younis* | ||
| Abstract | ||
| Abstract In the present study the effect of drawing ratio in deep drawing process on the thickness distribution along the cup (wall, base and nose) has been performed. Obviously, the drawing ratio is the one of the most important parameter has been adopted to design the drawing die. Both experimental and numerical models were carried out on various drawing ratios (1.484, 1.589, 1.739, 1.908, 2.12 and 2.332).Tthe simulation results showed that the best drawing ratio is 1.484, which gives small difference between maximum and minimum thickness distribution along the cup. To examine the simulation results, experimental tests were performed one of the drawing ratios which shows the same behavior and pattern approximately. Keywords:ANSYS9, Deep Drawing Drawing ratio. | ||
| Keywords | ||
| KEYWORDS; Deep Drawing Drawing ratio | ||
|
Statistics Article View: 435 PDF Download: 2,976 |
||