- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Study of The Wear Rate of Some Polymer Materials In Different Conditions | ||
| Engineering and Technology Journal | ||
| Article 1, Volume 28, Issue 16, 2010, Pages 5165-5170 PDF (133.43 K) | ||
| DOI: 10.30684/etj.28.16.3 | ||
| Authors | ||
| Awham M. H; Sadeer M. M; Bushra H. M | ||
| Abstract | ||
| The current investigation is interested by study of the wear phenomenon for two polymeric materials (Epoxy and Unsaturated polyester) resins, the prepared specimens were tested at room temperature by using two different loads(10,20)N for various testing times with different sliding distances. The resulted wear rates were calculated for each sample apart with. Variation the previous variables. To produce more precise idea about the wear characteristics of both above materials when immersed them in water environment, the study of wear rates was carried out for different immersion times at different temperatures when the above mentioned variables were fixed. It was found after comparing the results which obtained from the wear test in air that Epoxy resin undergoes higher wear rates than unsaturated polyester resin in general with variation the testing parameters, while the results of immersion in water which acts as plasticizing factor for polymers exhibited different effect on the wear behavior of the materials under study. | ||
| Keywords | ||
| Wear Rate; resin; Epoxy; Unsaturated polyester; immersion | ||
|
Statistics Article View: 439 PDF Download: 281 |
||