Laboratory Investigation on Efficiency of Model Stone Column Groups

T. Shlash, Kais; Y. Fattah, Mohammed; J. Mohammed Al-Waily, Maki

doi:10.30684/etj.27.9.1

	Laboratory Investigation on Efficiency of Model Stone Column Groups
Engineering and Technology Journal
Article 1, Volume 27, Issue 9, 2009, Pages 1673-1690 PDF (324.24 K)
DOI: 10.30684/etj.27.9.1
Authors
Kais T. Shlash; Mohammed Y. Fattah; Maki J. Mohammed Al-Waily
Abstract
As in piles, the efficiency of a group (Eg) of stone columns is defined as the ratio between the capacity of the group to the capacity of each stone column in the group multiplied by single stone column capacity. In this paper, the group efficiency of 24 model stone columns installed in soft clay is considered. These groups consist of 2, 3 and 4 columns. The tests were conducted on stone columns with length to diameter ratio (L/D) of 6 and 8. A laboratory setup was manufactured in which two proving rings were used to measure the total load applied to the soil-stone column system and the individual load carried directly by the stone column. The foundation steel plates have 220 mm diameter and 5 mm thickness. These plates contain 1, 2, 3 and 4 holes, respectively. The spacing between all holes equals twice the stone column diameter (D), center to center. The stone column capacity is taken as the load corresponding to a settlement equals to 50% of the diameter of stone column. The results illustrated that the group efficiency decreases with increasing the number of stone columns, also the stone columns with L/D of (8) provided higher efficiency than those with L/D of (6).
Keywords
Stone columns; group; Efficiency; laboratory model; Soft clay

Statistics Article View: 283 PDF Download: 192