- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Mechanical Strength of Alumina Compacts Lubricated withPoly (methacrylic acid esters) Copolymers | ||
| Iraqi Journal of Physics | ||
| Article 1, Volume 8, Issue 11, 2010, Pages 48-52 | ||
| Authors | ||
| Inaam M. Abdulmajeed; Hadi S. Al-Lami | ||
| Abstract | ||
| In recent years, there has been a rapid development in research on high performance ceramics for mechanical, electrical and medical industries. This development will be shown for alumina as a representative for oxide ceramics powders.Dry–pressing forming technique was used to prepare different ceramic compacts for alumina grafted by polymethacrylate polymers. All Alumina compact were fired firstly at 1200 ْ C, then at 1600 ْ C.Mechanical strength was examined in different means, some depends on compression and other depends on impact. Hardness was also measured .The results obtained were compared with that of Alumina compact prepared under the same condition from Alumina especially made for pressing .The results revealed that the compacts lubricated with polymethacrylate copolymers had higher mechanical properties than that prepared from Alumina made especially for pressing, reflecting the good capability of those polymers to act as lubricant for Alumina particles, this was supported by scanning electron microscope. | ||
| Keywords | ||
| alumina; Lubricants; mechanical strength | ||
|
Statistics Article View: 150 PDF Download: 42 |
||