- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Study the Optimization Parameters for Spring Back Phenomena in U-Die Bending | ||
| Engineering and Technology Journal | ||
| Article 1, Volume 31, Issue 9, 2013, Pages 1705-1718 PDF (838.48 K) | ||
| DOI: 10.30684/etj.2013.82184 | ||
| Authors | ||
| Karem M.Younis; Aseel Hamad; Khalida K.Mansor | ||
| Abstract | ||
| The main objective of the research is to find the optimum parameters that reduce the springback by using the commercially [SPSS] program to analysis data and find the best parameters which given lowest springback in the U-die bending. A commercial aluminum alloy [AL-1050] sheet (0.9 mm) thickness that founded when punch speed increase the springback increase, when rolling direction angle is 90 Lower springback, and when increase the dwell time decrease the springback, and the value of parameters predicted from [SPSS] have lower springback and obtain a goal dimension for the products. And predict the springback value by especial equations which given correlation coefficient 95.4% between the observed value of the dependent variable and the predicted value. | ||
| Keywords | ||
| springback; SPSS Program; Die Bending; aluminum | ||
|
Statistics Article View: 402 PDF Download: 165 |
||