- All Journals
- Al-Qadisiyah University
- Basrah University
- Kirkuk University
- Mosul University
- The Iraqi Borad for Medical Specialization
- University of Anbar
- University of Technology
- Al Mustafa University
- Al-Zahraa University for Women
- Alnoor University
- Kunooz University
- Misan University
- Ninevah University
- Tikrit University
- University of Al-Hamdaniya
- University of Kerbala
Experimental and Theoretical Study of Vacuum Cooling System | ||
| Engineering and Technology Journal | ||
| Article 3, Volume 31, Issue 14, 2013, Pages 2619-2631 PDF (664.42 K) | ||
| DOI: 10.30684/etj.31.14A.3 | ||
| Authors | ||
| Ahmed A. M. Saleh; Qussai J. Abdul Ghafour; Luay T. Al-Rawi | ||
| Abstract | ||
| A vacuum cooling system and the parameters which affect on its performance were studied experimentally and theoretically. For the experimental study the rig was built up to studying the performance of cooling system in three cases. These cases are: Cooling water by vacuum only, cooling water in conventional method, and cooling water by vacuum with condensation. The experimental results show that the addition of a condenser to the vacuum cooling system leads to sweep of largest amount of generated vapor, also the time consumed for the process was decreased. The times required for cooling 45 g from water from temperature 29oC to 10oC for the three test cases were 4375 second, 3535 second and 263 second, respectively. Vacuum cooling with condenser is a fast cooling of three systems test, which is about (13.7 times) faster than the system of natural convection cooling. To work properly, the existence of condenser is very important in vacuum cooling. It normally removes the large amount of water vapor generation (about 94%). For the theoretical study, a computer program was built up by employing the governing equation to simulate the performance of the vacuum cooling system. The theoretical results indicate an acceptable agreement with the experimental results. Also, the results show that the decreasing of condenser temperature causes decreasing of cooling time according to the equation (t = 0.2031Tcd4 - 2.8958 Tcd3 + 16.406 Tcd2 - 21.104 Tcd + 313.39), and increasing the evaporation surface area leads to decreasing of cooling time according to the equation (t=1/ (0.0006*Area+0.0005)), and the increasing of water mass causes in increasing of cooling time according to the equation (t=7.2667*mass+14). | ||
| Keywords | ||
| Vacuum Pump; Condenser; Cooling Effect; Compared; Vacuum Cooling; Mass Transfer | ||
|
Statistics Article View: 392 PDF Download: 332 |
||