Temperature Effect on the Hardness of Different types of Resin Denture Base Materials

Amal Abdul-Latif Rashid, Dr.; Preventive Dentistry, M.Sc.; Lecturer,

	Temperature Effect on the Hardness of Different types of Resin Denture Base Materials
MUSTANSIRIA DENTAL JOURNAL
Article 1, Volume 10, Issue 1, 2013, Pages 69-76
Authors
Dr. Amal Abdul-Latif Rashid; M.Sc. Preventive Dentistry;
Abstract
The cold cured acrylic resin is inferior to heat cured acrylic resin from stand point of strength and degree of polymerization. Many attempts have been made to improve these properties. Because heat affects maturity of the chemical reaction of acrylic resin therefore its maintenance during polymerization will affect the properties of cured resin. The purpose of this study was to evaluate the effect of increase curing temperature on the hardness of two commercially available cold cured acrylic resin material (Holland and Germany type) in comparison to heat cure resin and to those(cold cure) curing by conventional methods in air at 23°C ± 5°C. Ninety specimens,10 specimens from heat cure resin curing by water bath(short cycle) and eighty specimens from cold cured acrylic [forty from cold cured acrylic(Holland Type) and forty from cold cured acrylic(Germany type)] were prepared , flasking and packing procedure were done according to manufacturer direction and divided according to processing as follow:20 specimens(10 from Holland type and 10 from Germany type) were processed in air for two hours at 23°C ± 5°C under press (bench curing) as a control, and 60 specimens(30 from Holland type and 30 from Germany type) were processed by ivomat curing device containing water under air pressure 30 Pascal for 15 minutes at different temperature: 40°C, 60°C, and 80°C(10 specimens for each groups) .All specimens were tested for hardness test by shore D device (adigital model) for measuring the indentation hardness of the specimens the test load was set to 50 Newton for shore (( D ))which is suitable for acrylic resin material . Result showed that heat cure resin show the maximum value of hardness (88.8),followed by cold cured acrylic type Germany( polymerized by elevated temperature 80˚C) (88.696) followed by cold cured acrylic type Holland polymerized at 60˚C(88.471). While control group type Germany (polymerized at air bench) recorded the minimum value of hardness (81.83). All groups that polymerized at high temperature: 40°C, 60°C, and 80°C show the higher value of hardness in comparison to those processed by conventional methods (at air bench at 23°C ± 5°C) with significant and highly significant differences. There were highly significant differences between heat cure acrylic and cold cure (both types) processed by conventional methods and with cold cure Holland type processed at 40˚C, but there were no significant differences between heat cure acrylic and cold cure (both types) processed at high temperatures.
Keywords
Key Words; Hardness; temperature

Statistics Article View: 18 PDF Download: 6