A Numerical Analysis on Pullout Capacity of Batter Pile Groups in Sandy Soil

Al-Tememy, Mais S.; Al-Neami, Mohammed A.; Asswad, Mohammed F.

doi:10.30684/etj.2021.131818.1062

	A Numerical Analysis on Pullout Capacity of Batter Pile Groups in Sandy Soil
Engineering and Technology Journal
Article 1, Volume 40, Issue 11, 2022, Pages 1352-1357 PDF (865.4 K)
Document Type: Research Paper
DOI: 10.30684/etj.2021.131818.1062
Authors
Mais S. Al-Tememy^* ¹; Mohammed A. Al-Neami²; Mohammed F. Asswad²
¹Civil Engineering Department , Geotechnical , University of technology , Baghdad, Iraq
²Civil Engineering Dept., University of Technology-Iraq, Alsina’a street, 10066 Baghdad, Iraq
Abstract
Batter piles or raker piles are the piles driven in the soil at an inclination with the vertical to resist inclined forces or large lateral loads. Battered piles are widely utilized to support offshore buildings, towers, and bridges since these structures are risky due to the exposure to overturning moments resulting from winds, waves, and ship impact. This paper used a three-dimensional finite element analysis using PLAXIS 3D software to study the effect of several variables that affect the behavior of batter piles in a group under pullout loads. The study is conducted on a steel pipe pile model embedded in a dry sandy soil with three different relative densities (loose, medium, and dense sand) at different inclination angles and three embedment ratios L/D of 25, 37.5, and 50, respectively. The finite element model was carried out on a pile group of 2×1 with different configurations. The numerical results indicated that for all pile configurations, the pullout capacity of the batter pile group increased when the embedded ratio and relative density increased, and the maximum value was attained at a 20° batter angle. Furthermore, batter pile groups with BB (group with two battered piles) configuration of (-20°, +20°) gave a high resistance to the pullout load compared to other configurations of the pile group. In addition, pile Groups with battered piles marked the resistance to the pullout load more than pile groups that contain only the vertical piles.
Highlights
The pullout capacity of a batter pile group attains maximum value at a 20° batter angle Batter piles have a higher lateral load resistance than vertical piles. The pullout load capacity of groups increases with the increase in the embedment ratio Pullout capacity of vertical and batter piles improves significantly with increasing RD The negative batter pile group has more load capacity than the positive batter pile group
Keywords
Batter pile; Pullout capacity; Batter angles PLAXIS 3D

References
[1] M. Atici, A 3-D numerical model for pullout capacity of single batter piles in sand. Concordia University, 2009. [2] L. Hazzar, M. N. Hussien, M. Karray, 3D modeling laterally loaded battered piles in sand, 68e Conférence Can. Géotechnique 7e Conférence Can. sur le Pergélisol, 20 au 23 Sept. 2015, Québec, Québec., no. September, 2015. [3] F. H. Rahil, M. A. Al-Neami, K. A. N. Al-Zaho, Effect of relative density on behavior of single pile and piles groups embedded with different lengths in sand, Eng. Technol. J., 34 (2016). [4] [N. Parthipan and M. Kumar, Experimental study on uplift load carrying capacity of steel pile in sand, 2017. [5] T. Singh, M. Pal, and V. K. Arora, Modeling of oblique load test on batter pile group based on support vector machines and Gaussian regression, Geotech. Geol. Eng., 36 (2018) 1597–1607. https://doi.org/10.1007/s10706-017-0413-7 [6] V. Naveen, P. D. Arumairaj, S. Janaki Raman, Model researchon oblique load carrying capacity of batter pile groups, Int. J. Innov. Technol. Explor. Eng., 8 (2019) 880–883. doi: 10.35940/ijitee.F1178.0486S419. [7] T. T. Sabbagh, O. Al-Salih, I. Al-Abboodi, Experimental investigation of batter pile groups behaviour subjected to lateral soil movement in sand, Int. J. Geotech. Eng., 2019. [8] W. T. Gebresilassie, Numerical Investigation of single Batter Pile Due to Inclined Loads, no. June, 2020. [9] M. A. Al-Neami, F. H. Rahil, and K. S. Al-Bayati, Behavior of batter pile group models embedded in sandy soil under monotonic loading, in IOP Conference Series: Materials Science and Engineering, 737 (2020) 12088. https://doi.org/10.1088/1757-899X/737/1/012088 [10] M. A. Al-Neami, F. H. Rahil, K. S. Al-Bayati, Bearing capacity of batter piles embedded in sandy soil, Int. J. Geotech. Eng., 10 (2016) 529–532. https://doi.org/10.1080/19386362.2016.1203094 [11] M. Budhu, SOIL MECHANICS AND FOUNDATIONS, (With CD). John Wiley & Sons, 2008. [12] M. A. Al-Neami, M. H. Al-Dahlaki, and A. H. Chalob, Effect of Embedment and Spacing Ratios on the Response of Lateral Load of Single and Group Piles, Eng. Technol. J., 39 (2021) 1144–1152. [13] M. A. Al-Neami, H. H. Baqir and S. H. Hameed, Behavior of Single Micropile Under Different Lateral Load Rates, Eng. Technol. J., 39 (2016) 167–179.
Statistics Article View: 464 PDF Download: 479